Ba1258B_RemoteRig_MkIIs-A33.docx
Microbit 2.0 AB 2010. All rights reserved
Step by step system setup
Below follows a recommendation about how to proceed when setting up the system.
1. Spend some time to read thru this user manual to get familiar with the product.
2. Apply 12V DC (good stabilized power) to both units.
3. Connect both units with CAT5 patch cables to the same Ethernet switch or router as
your PC which you will use to setup the system is connected.
4. Download the Microbit Setup Manager and the latest firmware from
http://www.remoterig.com to your PC. Follow the instructions about how to install the
Microbit Setup Manager (see chapter Configuration with Microbit Setup Manager).
5. Find out how your network is configured and configure the RRC to fit into your network
(see chapter Initial IP Setup via LAN) with the Microbit Setup Manager. This has to be
done with both units.
6. When you have configured the units to fit into your network, Start your Web browser
and connect to the units one by one by entering their resp. IP-address. If you get in
contact with their internal web server everything is OK. ( You can also use the Browse
button in the Setup manager)
7. Check the installed firmware version. If the one you downloaded from Remoterig is
newer, update the units with the new firmware. Always update both units to the same
version (see chapter FW/HW about how to update).
8. Disconnect all cables from the units and open the housings (see chapter Strappings
and jumpers) and make the hardware strapping according to the instruction which is
provided in the chapter for your radio in the end of this User manual. Check the red
jumpers with a ohm meter to verify that they are not broken before assembling the
housings again.
9. Make the basic software configuration for your system which is described in the
chapter for your radio in the end of this Users manual.
10. Prepare the cables needed for your radio station and/or PC according to the cable
drawings provided in the chapter for your radio in the end of this User manual. Double
check your home made cables with an ohm meter before connecting them to the RRC
and the radio to prevent harm of any equipment. Microbit do not take any
responsibility of damaged RRC-units or radio equipment.
11. After preparing the cables connect them to the RRC-units and the radio equipment.
Connect the power to all equipment. Check with your web browser again that you are
in contact with both RRC-units.
12. Now try to establish the connection between the Control-RRC and the Radio-RRC. If
you use a radio with a detached control panel it’s done when you press the ordinary
power on button. If you are using a PC-at the control end you need to browse to the
status page in the Control-RRC and connect by clicking on the “Connect” button on.
(49 Seiten)
(27 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern