
Ba1258B_RemoteRig_MkIIs-A33.docx
Microbit 2.0 AB 2010. All rights reserved
Audio tones-dB [70-0]
(Control-RRC only)
You can set the level of the different status tones
generated by the RRC
70-0
30 (default)
IP identification
(morse)
(Control-RRC only)
Makes it possible to let the Control-RRC to send it’s IP
number in morse code, can be useful when DHCP is
used.
No (default)
Yes
Full Duplex
(Control-RRC only)
Makes it possible to use full duplex. Eg. the speaker
will not be muted when PTT is pressed. To use the
function “Continuous RTP Tx” must be activated in the
Radio-RRC.
No (default)
Yes
Yaesu pwr-on/off
(Radio-RRC only)
Is used to switch on and off Yaesu FT-
450/950/2000/5000/9000radios automatically on
connect/disconnect when radiomode 4 or 10 is used.
No (default)
Yes
PTT-off mute delay
(Control-RRC only)
Makes it possible to mute chirps coming from Tx-
monitor audio when PTT is released.
0-999 (0 = default)
The RTP packets can be tagged for ToS according to
RFC 791 to make it possible to use QoS in networks
which support QoS. The parameter is entered in
decimal.
0 (default)
UDP antenna-switch
port (Radio-RRC only)
Sets the port to which the Remoterig 10 x Antenna
switch should connect to, Should match the settings in
the antenna switch.
13010 (default)
In some very rare situations routers/ISP will not
transfer very short UDP messages. In this situations
you can set the min data size of the message. The
message is filled out with dummy data.
0-100
0 (default)
Kommentare zu diesen Handbüchern