Microbit RRC-1258 MkII(s) Bedienungsanleitung Seite 94

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 236
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 93
USER MANUAL
m crob t
RRC-1258 MKII
Ba1258B_RemoteRig_MkIIs-A33.docx
Microbit 2.0 AB 2010. All rights reserved
a
User manual
Rev. A33 2015 Jan 28
94 of 236
Connections
PAD Control-RRC:
At the Control-RRC the PAD-jack is used to connect a CW-paddle. The input is for a standard
3.5 mm stereo plug. The left paddle is connected to the tip and the right paddle to the ring.
Common is connected to the inner ring and house. Note - these signals are also available in
the I/O-connector.
Signal
PAD jack
IO setting
left-paddle
tip
-
right-paddle
ring
-
gnd
inner ring
-
PAD Radio-RRC:
At the Radio-RRC the PAD-jack is used to connect the output signal from the CW-keyer to the
radio straight-KEY input. The output is for a standard 3.5 mm stereo plug. A standard cable
with 3.5 mm connector in both ends can often be used. Note - these signals are also available
in the I/O-connector.
Signal
PAD jack
IO setting
keyer-output
tip
OUT2 mode = Keyer
keyer-output
ring
OUT1 mode = Keyer
gnd
inner ring
-
USB Control-RRC:
A PC with straight-key functionality can be used to perform the keying, alone or in
combination with a CW-paddle. To activate keying the PC could use the DTR signal in the
virtual USB COM-port delivered by the RRC USB device. The PC control works in parallel with
the CW-paddle so it is possible to shift between PC-keying and the CW-paddle without
changing the configuration.
I/O-connector Control-RRC:
A PC with straight-key functionality or other external keyer can be used to perform keying,
alone or in combination with a CW-paddle. To activate keying connect pin-4 (IN0) to GND.
The external keyer works in parallel with the CW-paddle so it is possible to shift between
external keying and the CW-paddle without changing the configuration.
Note - The straight-key input (IN0) is a generic input and cannot be connected direct to a PC,
you need an interface, see appendix.
Seitenansicht 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 235 236

Kommentare zu diesen Handbüchern

Keine Kommentare